May I know the parameters of the Cavitation Cycle model?

Dear all,

I found an interesting model from the mainpage of Mathworks. It is Cavitation Cycle model under simscape. However, I can only find a picture of the model without any parameters. Would you please provide me with the relative parameters of the cylinder and the orifice? Many thanks!

Best regards,

Chao Luo

Answer 1

[Abhinav]

Hi CHAO

Refer to the below documention link there on top right you will find a copy command button, copy the command and run it in Matlab, this will open the Caviation Cyle model in Simulink, there you can find all the information pertaining to this model.

Cavitation Cycle

Answer 2

[CHAO LUO]

Dear Abhinav,

Many thanks for your patient answer. I know the button you mentioned. The copied command is 'ssc_hydraulic_cavitation_cycle'. I tried to run the command in Matlab. however, Matlab can not recognize the command. If you can open the model, would you please send the mode of Cavitaiton Cycle to me? Many thanks for your great help.

Best regards,

Luo Chao