Servo motors connected to the aux channel of Pixhawk jitter
8 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Daehee Lim
am 25 Okt. 2022
Beantwortet: Manoj Velmurugan
am 31 Okt. 2022
I uploaded the auto generated code to pixhawk and I connected two servo motors to the aux out and main out respectively.
The servo motor connected to the main out moves with the increasing throttle position, however, the servo motor connected to the aux out jitters whether the throttle increases or not.
What do I need to do?
1 Kommentar
Manoj Velmurugan
am 27 Okt. 2022
I checked your model's configuration which appears fine. 50Hz PWM frequency for servos should be fine.
You could try using a logic analyzer on servo channel to observe the ON time. In case that fluctuates, problem is on the input side.
Else it could be a power supply issue.
Akzeptierte Antwort
Manoj Velmurugan
am 31 Okt. 2022
I checked your model's configuration which appears fine. 50Hz PWM frequency for servos should be fine.
To find the exact cause, you could try using a logic analyzer on servo channel to observe the on-time of PWM signal going to the servo. In case it fluctuates, problem is on the generated PWM signal.
Else it could be a power supply issue.
0 Kommentare
Weitere Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!