I have not been able to send data to the board (TMDSDOCKF28335) and receive it back in the Testing Environment.
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I'm trying to build a firmware aimed at processing a signal received from serial communication by the MCU and, then, send it back to the host PC. The model I made is shown below :
In the output I recieve nothing from here. However, when I replace the SCI Receive block directly with the constant [0.3] then it works fine. So, its clear that either Serial Send or Serial Receive block on the Testing environment is not functioning.
Also, as per the board guide,
I have tried it connecting Jumper J9. It still does not work.
Is there something I'm missing. I would be grateful for any suggestions.
Thank you!
0 Kommentare
Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!