it puts the contour graph at z=0 which is the top of the graph (the top of the hull) I need it at the other end of the z-axis. I made those numbers up, sorry for the confusion. My Z axis is decreasing, so 0 is at the top and -2 is at the bottom. I need the contour plot at -2 which would be all the way under the hull, not at 0 which is on top of the hull.
3-d plotting surface and contour
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I am trying to plot a figure (a ships hull). I want to plot a surface plot and a contour plot but I want the contour plot on the bottom of the Z axis. So if the z axis runs from 0 up to 2 the hull goes from 2 down to 1. Then i want a gap and the contour plot on 0 so its at the bottom of the graph not at the bottom of the figure. I tried using surfc and surf and contour but I can't figure out how to move the contour graph down the Z axis so it is separate of the hull. I hope that makes sense. Thanks.
Antworten (2)
Fangjun Jiang
am 30 Sep. 2011
Will this example help?
A=peaks;
surf(A+10);
hold on;
contour(A);
grid on;
0 Kommentare
Walter Roberson
am 30 Sep. 2011
You should not require anything more than "hold on". contour() outputs patch objects that, in effect, have Z of 0.
0 Kommentare
Siehe auch
Kategorien
Mehr zu Surface and Mesh Plots finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!