How to switch uitab using commands?

2 views (last 30 days)
Albert Bing
Albert Bing on 11 May 2022
Commented: Albert Bing on 11 May 2022
I wrote a GUI program and needed to switch uitabs. Is it possible to switch to next uitab using command? Suppose I had 2 axeses, ax1 & ax2, axis(ax2) would switch to ax2, so how to switch uitab using commands?
If not possible, how to send a shortkey in MATLAB? If I can send a shortkey "ctrl+tab" using a command, it will do the uitab switching job.
P.S. the program uses figure, not uifigure.

Accepted Answer

cr
cr on 11 May 2022
Edited: cr on 11 May 2022
Use SelectedTab property of uitabgroup.
E.g.
f = figure;
tabgp = uitabgroup(f,'Position',[.05 .05 .3 .8]);
tabA = uitab(tabgp,'Title','Tab A');
tabB = uitab(tabgp,'Title','Tab B');
tabgp.SelectedTab = tabA; % Switch to tab A
tabgp.SelectedTab = tabB; % Switch to tab B
Regards
  1 Comment
Albert Bing
Albert Bing on 11 May 2022
Ah, it's a property of uitabgroup, a litttle like the case in uibuttongroup.

Sign in to comment.

More Answers (0)

Categories

Find more on Maintain or Transition figure-Based Apps in Help Center and File Exchange

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by