Why Steady-state Pressure drop across a simple pipe in Simscape not in line with the manual calculation?
4 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I have a constant gas flow source connected with a pipe model. The mass flow is 2 kg/s. The pipe is with diameter 160mm, length 100m. I have attached the simulink model.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/915704/image.png)
According to help page, I calculated the pressure drop as 128 * mu_I * m_dot * Length / (rho_I * pi * D^4) ~= 180 Pa if mu_I = 18 * 10 ^(-6) and rho_I is 1.2 kg/m^3 for air at 20 degree.
The simscape simulation shows the pressure drop is 9000 Pa (see figure below), which is way off than the calcuated value. I know the density is underestimated as the steady-state pressure is 3.5 bar instead of 1 ATM. If taking that into account, the calculated value is even smaller.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/915709/image.png)
Since 3.5 bar is not a very high pressure, I pressume the dynamic viscosity is not too much affected by the pressure. mu_I = 18 * 10 ^(-6) is perhaps acceptable in the calculation? Could anyone help to explain where the calculation went wrong or why this discrepancy happens? THANKS.
0 Kommentare
Antworten (0)
Siehe auch
Kategorien
Mehr zu Foundation and Custom Domains finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!