State transition table outputs printing in diagnostic viewer

Dear Sir/Madam,

While my simulink model is running. In the diagnostic viewer I'm seeing the outputs of state transition table are printing during the entire siumlation. How can I avoid this printing of stateflow ouptuts in the Diagnostic viewer?

Any suggestions are highly appreciative.

Thank you in advance !

Answer 1

[Mark McBroom]

Most likely this is due to a missing semicolon to terminate a MATLAB statement in your statechart.

[yojitha etikala]

Hello Mark,

Sorry, There is a correction in my question. I'm seeing the outputs from state transition table not the state flow.