# Can I plot a subset (reduced frequency range) of S-parameters?

2 views (last 30 days)
Wis on 8 Oct 2014
Edited: Wis on 9 Oct 2014
I'd like to plot a some rfckt.passive S-parameters over a frequency range less than that of the circuit. Can I do that without creating a new circuit? I'd like to avoid an extra 'analyze' step.

Sandip Kumar on 9 Oct 2014
You can use the 'plot' command and use the condition, value pair to define a range of frequency:
As written here: When plotting large-signal S-parameters as a function of input power, you can specify frequency points of interest using condition/value pairs.
Thanks, Sandip, MathWorks

#### 1 Comment

Wis on 9 Oct 2014
OK, but how to specify the proper condition/value pairs? That's not at all clear on the cited page.

Wis on 9 Oct 2014
Edited: Wis on 9 Oct 2014
I found this works:
% get frequency subset
plot_freqs = freq_list(1:2*end_freq_idx) ;
% define circuit over frequency range of interest
% ( "diff_two_port_Sparams" was created with "freq_list" )
diff_ckt = rfckt.passive('NetworkData',rfdata.network('Data', diff_two_port_Sparams(:,:,1:2*end_freq_idx), 'Freq', plot_freqs, 'z0', Z0*2)) ;
plot1 = plot(diff_ckt,'S12','db') ;

### Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by