saving simulation results as .bmp

I run a simulation from a mfile. there are some scopes in the simulink model and I would like to save these scopes as .bmp. i use saveas(gcf..) command. but at the end it saves another thing.

scopes_currentsDQ

saveas(gcf, ['.\caps\CurrentDQ\', ['CurrentDQ @ Speed=' num2str(SpeedCounter) 'RMS & Torque =' num2str(Torque_Demand) 'Nm'], '.bmp']);

itt does not save the currentsDQ results but a graph of a lookup table which is created before.

Answer 1

[Titus Edelhofer]

Hi,

if you have only one scope in your model, it's possible by

hFig = findall(0,'tag','SIMULINK_SIMSCOPE_FIGURE')
saveas(hFig, ...)

Note, that findall used this way finds all scopes ...

Titus

[Image Analyst]

Mehmet's "Answer" moved here:

Hello, I have a lot of scopes. How can I refer a specific scope?

[Image Analyst]

Try it and see. In that case hFig is probably a 1-D vector of handles. Refer to the one you want by its index.