Single use switch in Simulink Real-Time
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi,
I am using etherCAT for motor control in a real-time application. Simulink runs the entire simulation all at once, but I want to send position commands only once the drive and motor are actually ready for movement (i.e., drive enabled). I thought about two potential solutions:
- Delaying the initial position command for the amount of time it takes the equipment to get ready (around 5 sec), but I am sure there must be a more elegant solution to this issue.
- Using relay and enable blocks together. The issue with this solution is that the relay block runs every cycle, even after the drive enabled signal was received, which I am assuming adds to the computational requirements for every cycle.
Is there any block that runs every cycle up until a certain signal is received, and once that signal is received, triggers a subsystem to run from there on until the end of the simulation, all this while the block stops running in the future.
Thank you
0 Kommentare
Antworten (1)
Siehe auch
Kategorien
Mehr zu Schedule Model Components finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!