Signal Monitoring and Parameter Tuning, Connected IO, PIL Verification, and Deployment
R2026bLearn about the workflows for signal monitoring and parameter tuning,
Connected IO, PIL verification, and deployment of Simulink models to TI mmWave
radar boards
Monitor signals in real time and tune parameters while the executable is running on hardware, verify generated code with processor-in-the-loop (PIL) simulation, and deploy Simulink models, using the Read Detections block. You need Embedded Coder® to complete this workflow.
Topics
- Communicate with mmWave Radar Using Connected IO
Get data from TI mmWave radar before deploying the Simulink model on the hardware.
- Run PIL Simulation with TI mmWave Radar Board
Learn about PIL simulation with Texas Instruments® mmWave radar board by configuring Simulink model.
- Signal Monitoring and Parameter Tuning of Model Running on TI mmWave Radar Board
Use your host computer to monitor and control an application running on the target hardware.
- Build and Run Executable on TI mmWave Radar Board
Build, load, and run an executable on the ARM® Cortex® processor of the TI mmWave radar board.
