Installation und Einrichtung
Bevor Sie das Communications Toolbox™ Support Package for Analog Devices® ADALM-Pluto Radio verwenden können, müssen Sie:
Dieses Support Package gemäß der Anweisungen unter Install Support Package for Analog Devices ADALM-PLUTO Radio installieren.
Eine Verbindung zwischen Hostcomputer und Radio gemäß der Anweisungen unter Einrichtung von Guided-Host-Radiohardware herstellen.
Funktionen
configurePlutoRadio | Configure ADALM-PLUTO radio firmware |
findPlutoRadio | Report information about attached radios |
sdrdev | Create radio object for specific radio hardware |
Klassen
comm.SDRDevPluto | Create object for Analog Devices ADALM-PLUTO radio |
Themen
- Supported Hardware and Required Software
Get an overview of supported hardware and required software products.
- Install Support Package for Analog Devices ADALM-PLUTO Radio
Install the Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio.
- Guided Host-Radio Hardware Setup
Follow an automated hardware setup process to establish communication between the host and the radio hardware.
- Manual Host-Radio Hardware Setup
Follow a manual hardware setup process to establish communication between the host and the radio hardware.
- What to Do After Installation
After you have successfully installed the support package, you can do any of the following:
- Setup for Two Radios Connecting to One Host
Set up two radio hardware devices connected to one host computer.
- Uninstall Support Packages
Uninstall the support package using the Add-Ons panel.
Fehlersuche
Resolve issues encountered while installing or using the features of the support package.
