Community Profile

photo

Avinash Kumar


MVJCE

Aktiv seit 2015

Followers: 0   Following: 0

Kontakt

Statistiken

  • Thankful Level 1
  • First Answer

Abzeichen anzeigen

Feeds

Anzeigen nach

Frage


Centroid of a estimated polygon
I have created a polygon using estimate geometry. I need to find the center/centroid of the polygon. I am using the below code t...

fast 9 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


Undefined function 'selectStrongest' for input arguments of type 'uint8'.
While using the Surf feature i am getting this error "Undefined function 'selectStrongest' for input arguments of type 'uint8'."...

fast 9 Jahre vor | 1 Antwort | 0

1

Antwort

Beantwortet
How to enter MATLAB code here ?
Do you want to know how to post the code in forum or in matlab???

fast 9 Jahre vor | 0

Frage


Troubleshoot controlling motors with raspberry pi model B+
With raspberry pi b+ I have connected a motor driver ic board and want to control using matlab. I am using the following command...

fast 9 Jahre vor | 0 Antworten | 0

0

Antworten

Beantwortet
Arduino support package in matlab PROBLEM
if it is showing that then the setup is not done Properly and Then try a=arduino();

etwa 9 Jahre vor | 0

Beantwortet
Loop Raspi Camera board to continuously take picture
Thanks for the reply. After image is taken i am facing problem with the noise removal. The question is there in this link <http:...

etwa 9 Jahre vor | 0

Frage


Command for running l293d through raspberry pi B+ in matlab r2015a
I want to run motors connected to motor driver ic board l293d. I have assigned Gpio pins 16,20 & 21. In which 16 is enable. My c...

etwa 9 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


when using bwpropfilt it show undefined function
Hi i need to filter binary image based on area and perimeter but using the command bwpropfilt (as given in matlab website) is sh...

etwa 9 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


How to remove object from binary image based on area and perimeter
Hi everyone i am trying to make a object follower comparing with a reference image. The problem i am getting is after the final ...

etwa 9 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


Loop Raspi Camera board to continuously take picture
Hi everyone I am using Raspberry Pi B+ for an object following. Since i am new to matlab, i dont know much of commands. I want t...

etwa 9 Jahre vor | 2 Antworten | 0

2

Antworten

Frage


Unable to connect Rapberrypi B+ to MATLAB
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

etwa 9 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry pi
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

etwa 9 Jahre vor | 0 Antworten | 0

0

Antworten