Yashwanth

Last seen: etwa 2 Monate vor | Aktiv seit 2026

Followers: 0 Following: 0

Statistik

Feeds

Beantwortet
[aerospace toolbox] Does the satelliteScenario allow to add custom vectors?
Hi Sebastiano, No, satelliteScenario does not currently support adding arbitrary custom vectors directly to the visualization.Y...

etwa 2 Monate vor | 0

Beantwortet
launchpadXL F28379D interference between inputs of a same ADC
Hi Bertrand, One of the possible workaround resolution you can try is increasing "Acquisition Window", increase the ADC sample...

etwa 2 Monate vor | 0

Beantwortet
Using a Custom Cost Function (MSE + Residual Penalty) with trainlm for an AL-SSNN Model in MATLAB Deep Learning ToolBox
Hi Mohamad, One of the possible workaround solution you can try is to augment the output error vector, that is you can embed th...

etwa 2 Monate vor | 0

Beantwortet
Bus selector's non-virtual signal&virtual signal problem
Hi, I think the issue occurs because Scenario Reader outputs a dynamic bus, while Bus Selector requires a fixed bus definition....

etwa 2 Monate vor | 0

Beantwortet
TextScatter implementation does not expose the indices it chose for display when 'TextDensityPercentage' is used
Hi Marco, You can give a try on recovering the indices via label text, since your labels are the indices themselves, you can E...

etwa 2 Monate vor | 0

Beantwortet
Mismatch between Deep Learning HDL Estimator and Vivado Resource Utilization
Hi Juan, I believe the final bitstream uses ~90% CLB resources because Vivado adds timing-closure, interconnect, control, and c...

etwa 2 Monate vor | 0

Beantwortet
Error occurred during deployment to the hardware board. Check the 'Download Executable to Hardware' stage above for more details.[For LAUNCHXL-F28379D]
Hi Sarthi, You can try this possible workaround fix for the issue you are facing Use a CCS-generated ccxml instead of MATLAB’s...

etwa 2 Monate vor | 0

Beantwortet
How to bring absolute path of code replacement library to makefile generated during Software In Loop build?
Hi Noufal, If you’re managing paths via Simulink Project, reference project variables in your include directories (e.g., Custom...

etwa 2 Monate vor | 0

Beantwortet
unable to update maltab 2025b update 2
Hi Nina, you can refer to this article "Update an Existing Installation". https://www.mathworks.com/help/install/ug/update-math...

etwa 2 Monate vor | 0

Beantwortet
Adams/Simulink Co-Sim ERROR: Command 11 & AEI_Initialize error
Hi Liu, here are a few resolutions you can try : 1) Start with batch (non‑interactive) to get a clear error Switch the Animat...

etwa 2 Monate vor | 0

Beantwortet
How to install Matlab R2025B on WSL Ubuntu
MATLAB installer supports a text-based interface, you can use these commands to install MATLAB R2025b on WSL Ubuntu. This will s...

2 Monate vor | 0

Beantwortet
When generating code, is there a setting to turn type casting on/off?
Here is an article that provides information on Controlling Cast Expressions in Generated Code. This article should help resolve...

2 Monate vor | 0