Statistik
RANG
4.343
of 301.229
REPUTATION
12
BEITRÄGE
0 Fragen
21 Antworten
ANTWORTZUSTIMMUNG
0.00%
ERHALTENE STIMMEN
2
RANG
7.101 of 21.196
REPUTATION
148
DURCHSCHNITTLICHE BEWERTUNG
3.00
BEITRÄGE
20 Dateien
DOWNLOADS
222
ALL TIME DOWNLOADS
1487
RANG
of 173.512
BEITRÄGE
0 Probleme
0 Lösungen
PUNKTESTAND
0
ANZAHL DER ABZEICHEN
0
BEITRÄGE
0 Beiträge
BEITRÄGE
0 Öffentlich Kanäle
DURCHSCHNITTLICHE BEWERTUNG
BEITRÄGE
0 Discussions
DURCHSCHNITTLICHE ANZAHL DER LIKES
Feeds
Gesendet
Solar Fed Dual Active Bridge Converter with MPPT
Simulink model of solar PV fed DAB converter with MPPT, phase shift control, efficiency and power transfer analysis.
15 Tage vor | 13 Downloads |
Disturbance observer and prescribed time controller
Prescribed-time terms 1/(Tfc−t)1/(T_{fc}-t)1/(Tfc−t) blow up near TfcT_{fc}Tfc in discrete simulation, creating an impulsive c...
22 Tage vor | 0
Gesendet
AI-Based Dual Active Bridge DC Nanogrid System
Solar–Fuel Cell DC nanogrid with ANN-based DAB phase control and adaptive RL energy management for cost and CO₂ reduction.
22 Tage vor | 7 Downloads |
Comment utiliser les transformées de Laplace ? How to use Laplace transforms
Solving differential equations using the Laplace transform in MATLAB involves converting a time-domain differential equation int...
etwa 2 Monate vor | 0
Gesendet
three-level NPC–DAB–CLLC converter
three-level NPC–DAB–CLLC converter
etwa 2 Monate vor | 16 Downloads |
Gesendet
Dual Active Bridge (DAB) DC–DC converter with pi controller
A Dual Active Bridge (DAB) DC–DC converter is most commonly controlled using phase-shift modulation, where the phase difference ...
2 Monate vor | 31 Downloads |
Gesendet
DCDCBUCKBOOSTCONVERTER
buck–boost converter is a DC–DC converter in which the input is a stiff voltage source and the output voltage can be either lowe...
3 Monate vor | 2 Downloads |
Can you use MATLAB with AutoCad?
Yes—AutoCAD and MATLAB are used together in architectural acoustics. AutoCAD → draws the room geometry and layout MATLAB → cal...
3 Monate vor | 0
| akzeptiert
Gesendet
Realistic dishwasher controller simulation
Realistic dishwasher controller simulation comparing PI, Fuzzy, Reinforcement Learning, and ANN methods with 230V/500W load mode...
3 Monate vor | 1 Download |
Gesendet
Nanogrid with solar cell
A nanogrid is a small-scale power system (typically < 10 kW) supplying local DC and/or AC loads using distributed energy sources...
3 Monate vor | 5 Downloads |
Can't plot function
x = linspace(0,10); y = sqrt(1+x.^2)./sqrt(x.^4-x.^2+1); plot(x,y);
3 Monate vor | 0
Gesendet
Fast Averaged Model Simulation of Dual Active Bridge (DAB)
Averaged DAB model for real-time-like speed,Comparative analysis of PI, FLC, ANN, and AI-inspired controllers
4 Monate vor | 16 Downloads |
How to change font size of legend in simulink
You can change the font size of labels in a Simulink Scope either through the graphical interface or using MATLAB commands. To d...
5 Monate vor | 0
How to enable the Legend of the Simulink Scope??
Open the Scope, then run:fig = get_param(gcb,'ScopeFigureHandle'); % get scope’s figure handle print(fig,'-depsc','scope_output...
5 Monate vor | 0
Power Systems Simulation Onramp Bug, three phase systems, three phase domain, 2/3 blocks Task 4 Does the following block have the correct parameter settings?
ONCE THE CHECK THE RLC BRANCH AND CHECK IT WHETHER IT WAS KEPT AS EXPANDED THREE PHASE PORTS , OR ELSE REMOVE THE RLC , IN LIBRA...
6 Monate vor | 0
Power Systems Simulation Onramp error
@Taimour THE MISTAKE YOU HAVE DONE IS THAT YOU CONNECTED THREE PHASE GROUNDED NEUTRAL IN THE SCREENSHOT THAT IS THE MISTAKE . RE...
6 Monate vor | 0
Jag vill förlänga min licens
To renew your MATLAB license before September 30, log in to the MathWorks License Center, renew your license, and then reactivat...
6 Monate vor | 0
Gesendet
single-phase power-factor corrected AC-DC halfbridge boost
The design focuses on a single-phase power-factor-corrected (PFC) half-bridge boost converter operating in Discontinuous Conduct...
6 Monate vor | 6 Downloads |
Help needed with simulink onramp Discrete systems
IN SCOPE you have settings , click on display and you have to enable the legend in the scope . then it will be activated and th...
6 Monate vor | 1
Error in Load Flow analyzer with Phase shifted Transformer
Use the transformer’s winding connection + clock position (e.g. Yd5/Dy5 for ±150°) instead of manually cross-connecting delta te...
6 Monate vor | 0
When I choose to simulate temperature effects of battery, it takes too much time to simulate
Simulating battery temperature effects in MATLAB R2019b can be slow because it adds thermal-electrical coupling, making the syst...
6 Monate vor | 0
how do i share matlab with my student team?
MATLAB code can be shared easily through GitHub. If it’s Simulink, then all team members need MATLAB/Simulink installed (same or...
6 Monate vor | 0
Scope legend not recognized when submit the results.
In right hand side of the picture , click on the display and enable the legend and then it will display the result and the task ...
6 Monate vor | 1
| akzeptiert
Gesendet
BUCK BOOST CONVERTER
The Buck-Boost Converter provides a flexible range of outputs, making it suitable for applications where the input voltage may v...
7 Monate vor | 3 Downloads |
Differenece between "MATLAB for the MathWorks Certified MATLAB Associate Exam" and "MATLAB Fundamentals"
Yes, when you complete each individual course (like MATLAB Fundamentals) you get a separate course certificate, and if you finis...
7 Monate vor | 0
How to hold a value in simulink ?
In Simulink, you can hold the latest value of a signal until a reset condition (like the signal crossing zero) by using a zero-c...
7 Monate vor | 0
