Statistik
RANG
271.748
of 300.871
REPUTATION
0
ANTWORTZUSTIMMUNG
66.67%
ERHALTENE STIMMEN
0
RANG
of 21.100
REPUTATION
N/A
DURCHSCHNITTLICHE BEWERTUNG
0.00
BEITRÄGE
0 Dateien
DOWNLOADS
0
ALL TIME DOWNLOADS
0
RANG
of 171.460
BEITRÄGE
0 Probleme
0 Lösungen
PUNKTESTAND
0
ANZAHL DER ABZEICHEN
0
BEITRÄGE
0 Beiträge
BEITRÄGE
0 Öffentlich Kanäle
DURCHSCHNITTLICHE BEWERTUNG
BEITRÄGE
0 Discussions
DURCHSCHNITTLICHE ANZAHL DER LIKES
Feeds
Frage
Problems getting Master Transfer Block to function
I would welcome a pointer to some clearer documentation for the c28x SPI Master Transfer block in provided for TI MCU for use in...
etwa 3 Jahre vor | 1 Antwort | 0
1
AntwortFrage
SPI interface timing with deasserts
I'm looking for a way to read data from a Si8380S-IU chip from a TI F2337xD based processor. The Simulink examples for Master T...
etwa 3 Jahre vor | 0 Antworten | 0
0
AntwortenFrage
Problem with external mode and model running on target hardware
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for mod...
mehr als 3 Jahre vor | 1 Antwort | 0
1
AntwortHow to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
mehr als 3 Jahre vor | 0
Frage
Errors when examining CAN log output in Mathworks
I'm getting an error "Reference to non-existent field 'x_440V_Tripped' when attempting to load a CAN log file from a simulation ...
mehr als 3 Jahre vor | 1 Antwort | 0
1
AntwortFrage
Ordering of CAN signal ports, when CAN Pack/Unpack is using "CANdb specified signals"
Regardless of the order in the CANdb file or the bit order assigned to signals, CAN unpack will show its outputs in alphabetical...
mehr als 3 Jahre vor | 1 Antwort | 0
1
AntwortUnclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
mehr als 3 Jahre vor | 0
| akzeptiert
Frage
Unclear error message for Swicth-Case Action on model update
The error message "The action port on subsystem '......../Chip1_WriteBytes1' can only be connected to an If or Switch-Case and m...
mehr als 3 Jahre vor | 1 Antwort | 0
