Community Profile

photo

Kcire L


Last seen: 3 Monate ago Active since 2021

Statistics

  • Thankful Level 2

View badges

Content Feed

View by

Answered
Detect signal clipping and remove
I'd like the areas highlighted in red to be removed (or zeroed out) but without altering the time domain. I am not able to use ...

3 Monate ago | 0

Question


Detect signal clipping and remove
Hi, I have a signal from a microphone that is listening for respiratory audio. When the test subject talks or moves too much, ...

3 Monate ago | 3 answers | 0

3

answers

Question


Evaluating multiple MEMS microphones
Hello, I need to evaluate multiple MEMS microphones to weed out which one is the best for my application. I am looking for som...

4 Monate ago | 0 answers | 0

0

answers

Question


Looking for a Low Pass Filter ( < 100 Hz) that will work in Octave
Hello, I am looking for a low pass filter with a cutoff of 100Hz that will work in Octave. I have used the butter function, bu...

4 Monate ago | 1 answer | 0

1

answer

Answered
Amplitude increase after filter
and how is this applied to the raw siganl? filtfilt(sos, g, raw)?

7 Monate ago | 0

Answered
Amplitude increase after filter
I appreciate your assistance.. Unfortunately I don't have access to MATLAB until late next week and am currently using GNU Octav...

7 Monate ago | 0

Question


Find beginning and end points from a pulse
Hello, I am trying to determine the beginning and end points of a pulse like the plot below. I have seven of these pulses save...

7 Monate ago | 1 answer | 0

1

answer

Answered
Amplitude increase after filter
It isn't amplifying anymore but it is now reduced reduced amplitude. You say it shouldn't be off at all, but doesn't a filter ...

7 Monate ago | 0

Answered
Amplitude increase after filter
Now it is off by about a factor of 10, but is it safe to assume that is the normal reduction from the filtering? step4 = filtfi...

7 Monate ago | 0

Question


Amplitude increase after filter
Hello, I am using a moving average to filter and find the envelope of a raw signal. I am curious as to why the amplitude of th...

7 Monate ago | 5 answers | 0

5

answers

Question


Text output from script
Hello, I was wondering if there was a way to output a text report of certain values and variables from my matlab script. I am ...

8 Monate ago | 1 answer | 0

1

answer

Question


Label point on FFT plot
Hi, I have a plot of an FFT of a signal, I did a findpeak to find the pronounced frequencies, and now I would like to add a lab...

8 Monate ago | 1 answer | 0

1

answer

Question


Use findpeaks on specific frequency range
Hello, I am trying to find the two peaks just under 1Hz in the plot attached. I wasn't sure how to use findpeaks to do this, b...

8 Monate ago | 1 answer | 0

1

answer

Question


Automate pulse duration measurements
Hi, I need to find the beggining and end of pulses like the image attached. With those points, I'd like to find the duration o...

8 Monate ago | 0 answers | 0

0

answers

Question


Estimate volume from extracted pulse
Hello, I have extracted a pulse from an audio signal and would like to see if I can determine volume from each pulse. Does any...

8 Monate ago | 1 answer | 0

1

answer