Beantwortet
Substitute s for jw in a transfer function
Matlab uses the reserved constant "i" which is set equal to sqrt(-1). Using your transfer function as defined try the following...

mehr als 3 Jahre vor | 0

Beantwortet
Sample and hold block (Simulink) - initial value dominates at t = 0?
I don't have the DSP System Toolbox so have replaced the Sampe and Hold with a Triggered Subsystem which exhibited the same prob...

mehr als 3 Jahre vor | 1

| akzeptiert

Frage

Plots are stuck on semi-log axis
I have created an app that plots on UIAxes either with a plot command or semilogx command depending on a switch value. But once ...

mehr als 3 Jahre vor | 1 Antwort | 0

Frage

Calling a function using ode45 in App Designer results in unrecognized function
In a private method function in App Designer I am using an ode45 call that refers to another function defined within the same ap...

mehr als 3 Jahre vor | 1 Antwort | 0

Beantwortet
pdepe problem (numerical vs analytical solution)
I don't think you were summing the terms of your series expansion correctly. The attached code carries out the expansion summati...

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
Assigning roots as variables to a function
The output of the roots function can be assigned to a workspace array variable and printed out as you wanted. See the simple exa...

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
I have two voltage sources and I would like to get equal V_out from both sources to allow for a parallel connection. Does anyone have a suggestion on how I can use the Average DC DC converter to achieve this?
Trying to place power supplies in parallel with each will cause great unhappiness. At best you might tie the outputs together th...

mehr als 3 Jahre vor | 0

Beantwortet
Integrate a signal over the last x seconds
Using a combination of an integrator, transport delay and summer where you subtract the value of the integrator output from 30 s...

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
Fourier series of a sawtooth wave
You are multiplying by pi on the 2nd through 10th harmonics instead of dividing.

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
Solving probability problems with MATLAB
Here is my take using a for loop. I wouldn't mind seeing how it is done without using a for loop %% MonteCarloBadApples.m % Au...

mehr als 3 Jahre vor | 0