Community Profile

photo

Benjamin Hoepfner


Last seen: 3 Monate vor Aktiv seit 2021

Statistiken

  • First Answer
  • First Review

Abzeichen anzeigen

Content Feed

Anzeigen nach

Beantwortet
Is it possible to enable/disable the epwms of an F28379D Launch Pad via simulink?
Hi you can find the answer to this question in the link below: Link to ePWM interrupt Greetings from Benjamin

etwa ein Jahr vor | 1

| akzeptiert

Beantwortet
How to program an epwm interrupt in Simulink for a TI-F28379D Controller?
Hi, here the answer to my request and to the comment below: It is solved and its verry simple but hard to find.. In the epw...

etwa ein Jahr vor | 1

| akzeptiert

Beantwortet
Bode Diagram
Hi, i'm using version 2021a and i have a similar problem but the previous answer doesn't work in my case. I need the values of...

mehr als ein Jahr vor | 0

Beantwortet
How can I set the ADC Block for F28379D to ADCIN14 and ADCIN15?
Hi, the answer is, that the ADCIN14 & ADCIN15 are connected to each ADC module and it is possible to choose module A/B/C or D ...

mehr als ein Jahr vor | 0

| akzeptiert

Frage


How can I set the ADC Block for F28379D to ADCIN14 and ADCIN15?
Hi, i would like to programm a my TI controller Card F28379D and need to programm some ADCs. In more detail: I need to program...

etwa 3 Jahre vor | 2 Antworten | 0

2

Antworten

Frage


How to program an epwm interrupt in Simulink for a TI-F28379D Controller?
Hi, I would like to program a Controller and for that I need to interrupt or suppress the epwm generation. I use Simulink to p...

etwa 3 Jahre vor | 1 Antwort | 1

1

Antwort

Frage


Is it possible to enable/disable the epwms of an F28379D Launch Pad via simulink?
Hi, i would like to set up a control for a voltage source inverter wich needs a lot of epwms in A/B mode (one is on when the o...

etwa 3 Jahre vor | 1 Antwort | 0

1

Antwort