how to run a MATLAB model through GUI

i need to run a MATLAB model from GUI ,i had used sim command but i cannot see the simulation time , i need to see the simulation timing. I used following command "set_param(gcs,'SimulationCommand','start')"but when i run from GUI model run but i cannot see the scope waveform.can u suggest me how can i run a model from GUI and can see simulation percentage or timing

Answer 1

[Zack Peters]

Hi Milan,

If you save a model with the scopes open and then close the model, then the next time that you open that model, the scopes will open as well.

When you start the model via set_param you will get a full view of the model's simulation time at the right side of the model's status bar as well as continuous updating of the scopes.

You can see from executing the following code in the command window (try to simplify by taking the GUI out of the equation):

open_system('vdp')
set_param('vdp','SimulationCommand','start')

~Zack

[Phani kumar KSV]

thanks. it worked