Inactivate PID controller for 3 seconds
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Matt Hinesley
am 12 Jul. 2021
Kommentiert: Mathieu NOE
am 12 Jul. 2021
I have set up a PID controller to control wheel speed by manipulating torque on a wheel, but I would like this PID controller to kick in at t=3 seconds and output a torque of 0N*m until then. After t=3s, I would like the PID controller to function as if there was never any delay if that makes sense. I have tried the delay blocks, but the problem with those is that at any time t, the PID controller is using speeds from 3 seconds ago and not the current wheel speed. Is there a way to simply inactivate my controller until 3 seconds have passed and then have it function as normal?
Below is a screenshot of my feedback loop thus far:
0 Kommentare
Akzeptierte Antwort
Mathieu NOE
am 12 Jul. 2021
hello
simply add a switch block at the input side of the PID
the first signal (input) of the switch is zero, the second is the error torque
use a step signal to switch from the zero to error signal at time t = 3 s , so the PID will start to work after t = 3 s
2 Kommentare
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu PID Controller Tuning finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!