Spectrum Analyzer sample rate.
8 views (last 30 days)
Pratyush Roy on 12 May 2021
When you right click on the Spectrum Analyzer block and click on the "Properties" option, the following window will pop up:
After you click on the highlighted link, it leads you to the Spectrum Analyzer1 window which looks like the following:
On the top-left corner you can select Spectrum Settings(highlighted using Yellow) and then you can set the sample rate using the option as shown on the right (highlighted using Red).
Hope this helps!
Yoshi Minagawa on 21 May 2021
Please check the signal type of inport signal connected to Spectrum Analyzer Block. It must be a discrete signal. It is also written in the documentation.(see below)
If the signal is continuous and you want to change it to a discrete signal, please use Rate Transition block.(see below)
I hope this will help.