Running powergui block in different simulation modes within the same model

I want to run different parts of a model in different modes using powergui block. Different modes being discrete, continuous or phasor. Is it possible?

Answer 1

[MathWorks Support Team]

This is possible by dividing the photovoltaic(PV) system and the propulsion system as two subsystems. You can add two different powergui blocks (one in each subsystem) running in different modes. Important thing to keep in mind is that if you are using more than one powergui block in a model, then:

• Do not place a powergui block in the top-level diagram
• Place every independent model in a different subsystem
• Place a single powergui block in the top level diagram of every subsystem

You can read more about this here:  https://www.mathworks.com/help/sps/powersys/ref/powergui.html