Simple Matlab & Arduino Serial Communication
14 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I am attempting a running the following program and am getting strange results. After opening the serial port, the Arduino sends a "Ready" command to matlab. Then it sends a uint16 (2 bytes) value of 500 to the arduino. The arduino simply echoes what was received back to matlab in HEX.
When I run this I expect readData to equal 0x01F4, but I get 0xC0F4. Any suggestions?
Arduino CODE:
byte incomingByte1;
void setup(){
pinMode(2,OUTPUT);
Serial.begin(115200);
Serial.println("Ready");
}
void loop() {
digitalWrite(2,LOW); //turn off LED
delay(500);
if (Serial.available() > 0) {
digitalWrite(2,HIGH); //flash LED everytime data is available
delay(500);
incomingByte1 = Serial.read(); //read incoming data
Serial.println(incomingByte1,HEX); //print data
}
}
Matlab CODE:
clear
clc
s=serial('COM7','BaudRate',115200);
fopen(s);
readData=fscanf(s) %reads "Ready"
writedata=uint16(500); %0x01F4
fwrite(s,writedata,'uint16') %write data
for i=1:2 %read 2 lines of data
readData=fscanf(s)
end
fclose(s);
delete(s);
OUTPUT:
readData =
Ready
readData =
F4
readData =
C0
3 Kommentare
avram alter
am 14 Feb. 2019
It's been nearly 6 years, but from the bottom of my heart, thank you. this thing actually worked to solve my problems.
Antworten (1)
islam dib
am 8 Dez. 2020
Hello,
How can I read data sending from arduino via serial port, in Matlab?
2 Kommentare
Siehe auch
Kategorien
Mehr zu MATLAB Support Package for Arduino Hardware finden Sie in Help Center und File Exchange
Produkte
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!