Zero-Crossing Detection Error...
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hello Every One...
Recently I faced an error which i couldn't get rid of...
it is about consecutive zero crossing... the error occurs even when i disabled
the un-ticked the 'Enable zero crossing detection' of PID Controller but it
didn't work.
The error dialog is:
"to continue the simulation, you may 1) Try using Adaptive zero-crossing
detection algorithm or 2) Disable the zero crossing of the blocks shown in the
following table.
---------------------------------------------------------
Number of consecutive zero-crossings : 1000
Zero-crossing signal name : RelopInput
Block type : RelationalOperator
Block path : 'boostwithpicontrol/Relational Operator1'
---------------------------------------------------------
You can turn off this message by using the MATLAB command:
set_param('boostwithpicontrol','MaxConsecutiveZCsMsg','none');
"
Would You Please Help...
0 Kommentare
Antworten (0)
Siehe auch
Kategorien
Mehr zu General Applications finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!