linking values in command window to simulinl

i have values in command window 

t=0:0.1:10;y1=sin(4*t);
y=reshape(bsxfun(@times,repmat(y1,3,1)',[1 3 5]),1,[]);
close,

plot(y) will give the sine wave,but i need this sive wave to be plotted in simulink,and i need to see the graph in scope 

please help

if not is it possible to embedded these vales in simulink to get graph in scope

Answer 1

[Azzi Abdelmalek]

 ty=[t' y']

In your Simulink model use From Workspace block from Simulink/Sources and set data to ty

[Pat]

Azzi i get error

Error using ==> horzcat CAT arguments dimensions are not consistent.

[Pat]

Azzi please look at this i have done in command window i get error

http://www.sendspace.com/file/egd5gx

[Azzi Abdelmalek]

You've used repmat to y then you must change t. try this

t=0:0.1:10;y1=sin(4*t);
y=reshape(bsxfun(@times,repmat(y1,3,1)',[1 3 5]),1,[]);
t=0:0.1:(length(y)-1)*0.1
ty=[t' y']

[Pat]

Thanks a lot Azzi,i got it ,please can you tell is it possible to implement this in simulink by using anyblock,(without using from workspace block).i should not use m file,need to simulate directly in simulink

[Azzi Abdelmalek]

Use three sine wave block with diffrent amplitudes, pass them through a multiport switch

[Pat]

Azzi i used from workspace block ,but i am not getting increasing sine wave,is the axis worng,if so can you please tell how to change x and y axis in scope

please see this

http://www.sendspace.com/file/uhywgn

[Azzi Abdelmalek]

Because your stop time is 10 s, make it 30 s

[Pat]

Thans azzi please chk at this i get error while simulating

http://www.sendspace.com/file/aelhto

[Azzi Abdelmalek]

Pat, read the help of the multiport switch, Now I have to leave