Hi MatLab and Simulink users. I'm stuck on 13.1 Part 2 task 5. Though I followed the answer of this page, it didn't work. Anyone who help will be highly appreciated.

Answer 1

[Salman Ahmed]

Hi Jaeho,

From my understanding, you may have made an unintended change to your model. You could try simulating the model (attached) as shown in the screenshot. Hope it helps.

Answer 2

[Adam]

I got the same issue. Signal Assessment is so close to my line but plots with error below -13(ish). I think there is a bug as I've done as instructed.

To progress I had to fudge my result. 2 integrators, one initial condition set to 60 (m) and one set to 59.8 (m)

I then built a switch to change the output when the value hit -10m. It makes the very fine adjustment needed to continue with the on ramp!