Stepper motor programming on arduino using drv8825 on MATLAB

I am facing a problem while programming a stepper motor on arduino using drv8825 on MATLAB. The results are not same while programming on these 2 platforms.

On Arduino IDE its working as expected using the following code:

# define dirpin 2
# define stepPin 3
# define stepsPerRevolution 200

void setup() {
  // Declare pins as output:
  pinMode(stepPin, OUTPUT);
  pinMode(dirPin, OUTPUT);
}
void loop() {
  // Set the spinning direction clockwise:
  digitalWrite(dirPin, HIGH);
  // Spin the stepper motor 1 revolution slowly:
  for (int i = 0; i < stepsPerRevolution; i++) {
    // These four lines result in 1 step:
    digitalWrite(stepPin, HIGH);
    delayMicroseconds(600);
    digitalWrite(stepPin, LOW);
    delayMicroseconds(600);
  }
  delay(600);
  // Set the spinning direction counterclockwise:
  digitalWrite(dirPin, LOW);
  //Spin the stepper motor 5 revolutions fast:
  for (int i = 0; i < stepsPerRevolution; i++) {
    // These four lines result in 1 step:
    digitalWrite(stepPin, HIGH);
    delayMicroseconds(600);
    digitalWrite(stepPin, LOW);
    delayMicroseconds(600);
  }
  delay(600);
}

On MATLAB I have tried to program the same but results are not same as shown on Arduino, using the following code:

clear a
% Arduino Declaration
a = arduino('COM4', 'Uno');
StepPerRevolution = 200;

% Pin Configuration
configurePin(a,'D2','DigitalOutput'); %D2 = Direction pin
configurePin(a,'D3','DigitalOutput'); %D3 = Step pin
while true
writeDigitalPin(a,'D2',1);
for i = 0:StepPerRevolution
    writeDigitalPin(a,'D3',1);
    pause(0.0006);
    writeDigitalPin(a,'D3',0);
    pause(0.0006);
end
writeDigitalPin(a,'D2',0);
for i = 0:StepPerRevolution
    writeDigitalPin(a,'D3',1);
    pause(0.0006);
    writeDigitalPin(a,'D3',0);
    pause(0.0006);
end
end

Please help

[Conner Carriere]

Did you figure anything out, having issues also?