Real-time simulation with C2000 device
8 views (last 30 days)
I am trying to do a Real-time simulation with a F28004 DSP.
I am currently using the PIL block to check a component running on the DSP while simulating the work environment on the computer, but it has been noticed that the speed that runs the model on the device is around 15 ms instead of 10 us (for example).
Is there any way to make it Real-Time?
Antonin on 22 Mar 2019
PIL is not meant to be realtime. The primary use case for PIL is verification of the results produced by the generated code vs simulation.
If you are looking for a way to monitor signals in Simulink while the model runs in realtime on the hardware, you should use External mode.
Please refer to the answer provided on this page, it shows 3 different techniques to achieve this and points to a video where I demonstrate how to visualize variables updated at 200kHz (5µs).
I hope it helps,