Why do I receive error when I run a simulation on Simulink with a PIL block for Arduino Mega and gives that there is no connection with the Arduino board?
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I tried to run the example "Arduino_PIL_Block"(attached). I created the PIL block and located in the model as shown:
When I started the simulation in "Normal" mode I get the following error:
- Noting that I have no problem when I remove the PIL block and run the model in external mode or deploy the controller to the board after cancelling PIL creation.
- My MATLAB is 2017b 64bit and my OS is Windows 7 64bit.
2 Kommentare
elio zaccgnino
am 17 Jan. 2022
I have the same problem. Do you know if this example works with Arduino Uno Board?
Thanks in advance
Azizhan
am 30 Mär. 2023
Arduino Due works but Mega does not work to me!! Unf, MATLAB does not answer!
Antworten (0)
Siehe auch
Kategorien
Mehr zu Arduino Hardware finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!