How to update variable in Workspace during simulation?
43 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi all,
I have a simulink simulation that runs for 20s. At every 5s, it will generate a new set of data, which needs to be written to the workspace automatically. (Hence, the values in workspace should be updated automatically every 5s).
Right now, even though I try to write to the workspace every 5s, the values in the workspace remain at its initial value throughout the simulation and only update at the very end of the entire simulation time (i.e. after 20s).
May I know what should I do? Any advice or help is really greatly appreciated!
Best Regards, Rachel
0 Kommentare
Antworten (2)
Kaustubha Govind
am 29 Mai 2012
I'm assuming that you are using something like the To Workspace block to write data to the workspace? I explained a little in my second paragraph over here, why I think that operation is not guaranteed to be completed until the end of simulation.
However, it seems (from your comment to the cyclist's answer) the broader issue is that you are attempting to update a block parameter based on a signal. Read this blog post to understand why that cannot be done.
2 Kommentare
the cyclist
am 29 Mai 2012
I am not familiar with simulink, but will the assignin() command solve your problem?
>> doc assignin
3 Kommentare
Homer Lan
am 8 Feb. 2018
Hi, I met the same question with u. I want to update the value in the workspace when the simulink was running. And I use 'assignin',the value in the workspace can only save the initial value. And it cannot change with the simulation starting. How can I solve this? Thank you for your help!
Siehe auch
Kategorien
Mehr zu Simulink Environment Customization finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!