PID setpoint problem
35 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Moritz
am 16 Apr. 2012
Kommentiert: ojonugwa adukwu
am 16 Sep. 2022
Hi,
for my bachelor project I'm designing a controller for an inverted pendulum problem. The first simulation I have created in Labview but after purchasing MATLAB R2012a I wanted to try to 'translate' my simulation into simulink. It all works nicely except of one big problem. When I use a normal continues PID controller, the control works fine and it is controlled to the zero (equilibrium) point. Hence, the automatic set point of the PID(s) block seems to be zero (?). I have used the following values: P: 500, I:0.01, D:1, N:1. The form is ideal. Now, since I need to be able to set my setpoint myself I replaced the PID(s) block by the PID(s) 2DOF block (is this right?). Here I used: P: 500, I:0.01, D:1, N:1, b:1, c:1. I set the form to ideal and connected a 0 constant to the reference input. This (to my judgment) should be the same controller as the PID(s) was. However, the system now is highly unstable. What am I doing wrong? Where have I gone wrong? I only want the PID(s) block and set my own setpoint.
I hope this all makes sense!
Thank you so much in advance!
Regards
0 Kommentare
Akzeptierte Antwort
Arkadiy Turevskiy
am 17 Apr. 2012
Bearbeitet: Arkadiy Turevskiy
am 2 Okt. 2017
PID Controller block does not assume anything about the setpoint value, it operates on the error signal which is the difference between the setpoint and measured output.
If you want to control your pendulum around some non-zero angle, you do not need 2DOF PID. All you have to do is have a block for your setpoint (constant, for example). Set the value of this constant as you wish. Then substract measured angle to form the error signal, and feed this error signal to the PID Controller.
HTH.
Arkadiy
5 Kommentare
Sam Chak
am 16 Sep. 2022
Perhaps, you can make a new post on your query with the model of the system that you want to control.
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu PID Controller Tuning finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!