Variable frequency Square pulse - Simulink

Hi,

I would like to know how can I generate a variable frequency controlled square pulse with 50% duty cycle in Simulink? I wish to vary the frequency in the range of 2KHz to 5.5KHz. It would be nice if you guys could help me.

Thanks a ton!

Answer 1

[Quan Tao]

To generate a square pulse in Simulink, the Pulse Generator block can be used.

Assuming we are using Time based for Pulse type parameter and Use simulation time for Time (t) parameter, the desired waveform of the pulse can be configured by setting the Amplitude, Period (secs), Pulse Width (% of period), and Phase delay (secs) parameters.

Suppose we are using default values for Amplitude and Phase delay (secs). The Pulse Width (% of period) parameter should be set to 50 in order to produce a pulse with 50% duty cycle.

To vary the frequency of the pulse, the Period (secs) can be set based on a base workspace variable. For example, you can define a base workspace variable for frequency:

f = 2000;

Then you can set the Period (secs) parameter to 1/f, which generates a pulse with a frequency of 2 kHz. By varying the value of f, you will be able to vary the frequency of the generated pulse.

To learn more about the Pulse Generator block, please refer to the documentation page on Pulse Generator.

[Mohamed Haroon Abdul Jabbar]

Thanks for the reply. But, Can we give the input to Pulse Generator block, so that we can vary the frequency while the simulation is running? Looking forward to your reply.

[rami ghali]

hello Haroon, I currently need the exact something. Did you figure out how to vary the frequency while the simulation is running.

[Yanwen Lai]

I have same question as Haroon. Looking for solution yet.

[Ömer Nezih ATALAY]

I need that variable Pulse Generation also while simulation running, if you solve the problem please notify here, thank you.

[3so]

Hello Ömer Nezih ATALAY,

For me it looks straightforward, you can use a "mod" block with a "clock" to derive this pulse signal.

Regards,

Gadfly

[Charles Duruaku]

could you please explain how to vary the frequency in your block , i am looking for a chirp-like pwm. varies within a frequency range with a specified time.