Question about the "enable" block.
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
0 Kommentare
Akzeptierte Antwort
Weitere Antworten (2)
Arnaud Miege
am 18 Mär. 2011
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
0 Kommentare
Sébastien Malengé
am 18 Mär. 2011
2 Kommentare
Guy Rouleau
am 22 Mär. 2011
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
am 23 Mär. 2011
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
Siehe auch
Kategorien
Mehr zu Schedule Model Components finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!