Can BrickPi be programmed from Matlab/Simulink to control LEGO NXT sensors and motors?
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Gautam Goel
am 2 Jan. 2017
Kommentiert: Jannik Hahn
am 12 Mär. 2021
Hi, Has anyone tried controlling LEGO NXT sensors and motors via BrickPi over Raspberry Pi 3's on-board WiFi? BrickPi is essentially an expansion board to Raspberry Pi: https://www.dexterindustries.com/BrickPi/.
BrickPi officially does not support Matlab/Simulink yet. I am wondering if anyone can point me to relevant resources to help figure out how to access and control these motors and sensors. Thanks, Gautam
1 Kommentar
René van der Meer
am 24 Dez. 2017
Gautum, this is a very good idea! I would love to use this as well. I hope that someone already has done this. Otherwise would could start with the Dexter SW?
Akzeptierte Antwort
Jannik Hahn
am 9 Dez. 2019
Hi Gautam,
maybe a bit late, but you can use the "Simulink Support Package for Raspberry Pi Hardware" and control the motors and sensors via SPI. I actually use the "SPI Master Transfer" and extract the needed inputs from the c++ libraries provided by Dexters BrickPi3-master.
Cheers Jannik
6 Kommentare
Weitere Antworten (0)
Communitys
Weitere Antworten in Power Electronics Control
Siehe auch
Kategorien
Mehr zu LEGO MINDSTORMS EV3 Hardware finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!