Error occurred when evaluating apply callback [Instrument Control Toolbox]
46 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
I'm trying to send data on my serial port through Simulink with the toolbox in description, but when i configure the Serial Configuration Block, it give me this error. I don't think the problem can be the port, because i have atteched an Arduino Uno.
6 Kommentare
Mojtaba
am 10 Aug. 2016
I also have the same problem trying to connect to a virtual port for Ti MSP430 launchpad.
Antworten (5)
Juan Martinez
am 18 Okt. 2016
Bearbeitet: Juan Martinez
am 18 Okt. 2016
For anyone reading this I used to have this same problem; however, I think I found the solution. Simply connect your hardware (Arduino) to the computer before opening Matlab. Then (with the hardware connected) open Matlab, then open your Simulink model and configure the Serial Configuration Block, it should work just fine now. After doing so, you can save your Simulink model and the serial configuration will be saved as well.
8 Kommentare
Robert Sawrey
am 18 Aug. 2016
I had this problem, then ran Matlab in Administrator Mode, which fixed the issue.
1 Kommentar
Madhu Govindarajan
am 28 Dez. 2015
Have you tried using the Arduino Serial Transmit instead of the Instrument Control Toolbox one? I think that will resolve this issue.
1 Kommentar
Fox Hsu
am 26 Jan. 2016
i have the same problem. In my case, it turns out it's the conflict between 2 serial ports ( i'm trying to open 2 serial port in the same simulink model) cause this error message.
0 Kommentare
Siehe auch
Kategorien
Mehr zu Instrument Control Toolbox finden Sie in Help Center und File Exchange
Produkte
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!