How to scope and print UART data from STM32F4 evaluation board?
6 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Jung Sunghun
am 6 Jan. 2024
Kommentiert: madhan ravi
am 7 Jan. 2024
Hello all,
I am currently struggling to find out how to scope and print out an array of hex data as shown below.
It currently shows all zeros although the oscilloscope shows some data going to and coming from the STM32F4 board.
All wiring setup is correct since I successfully tested some other tasks.
I appreciate your help in advance.
1 Kommentar
madhan ravi
am 6 Jan. 2024
Bearbeitet: madhan ravi
am 6 Jan. 2024
As the message says , the Stm32 board uses a local timer so simulation time is not based
Akzeptierte Antwort
Jung Sunghun
am 7 Jan. 2024
1 Kommentar
madhan ravi
am 7 Jan. 2024
Perfect, thanks for providing feedback. Will be always useful for others as well. I knew how to do it in STM32Cubeide but not in Simulink since I don’t have the license.
Weitere Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!