How to get raw data of TI IWR6843ISK through Radar Toolbox

Radar Toolbox only offers a function to get deteced information like range, doppler and degrees. I wonder how to get raw data so that I can extract more information beyond that offerred by the function.

Answer 1

[Vatsal]

Hi,

I understand that you’re looking to extract raw data from the MATLAB Radar Toolbox. Here are the steps to follow:

• Navigate to: Firmware_Software → Communication Library → ComLib_Matlab_Interface → Examples → GettingStarted.
• Copy the path.
• Open MATLAB.
• Paste the path in the top tab.
• The “extract_raw_data.m” file will show up on the left tab.
• Connect the P2G board.
• Click on Run to see raw data.

You can also refer to the below link for the additional information:

https://community.infineon.com/t5/Radar-sensor/P2G-Problem-when-collect-a-raw-data-using-matlab-interface/m-p/342057#M272

I hope this helps!

Answer 2

[Gayatri Menon]

Hi,

Starting with MATLAB R2024b, the Radar Toolbox Support Package for Texas Instruments® mmWave Radar Sensors allows you to set up and collect raw ADC (IQ) radar data from the Texas Instruments IWR6843ISK using the DCA1000EVM capture card.

• Doc link
• Examples

Hope this helps

Thanks

Gayatri