xpc realtime udp receive

Does anybody have a short example how to use an xpc realtime udp receiver block? I am able to write out an udp packet to a "sensor" which will answer after receiving the packet. To check the answer, I am using wireshark. But I am not able to receive this packet with the xpc target.

It seems to me, that the xpc realtime receiver block is misconfigured or has a bug, may be the packet size is too short?

Was anybody able to use this receiver block successfully?

Answer 1

[Peter Wehrli]

There is a bug in the realtime udp receiver block. Below a certain amount of bytes, the block will not receive any byte. Actually I am testing a patch of MathWorks. In a short time the patch will be available on MathWork's support page.

Answer 2

[Mirko Kunze]

Any updates on this issue? I have the same problems and did not find any patches.

Answer 3

[Peter Wehrli]

go to bug report 783622 (xpc target, 2011b), there you will find the update!

[Celine Chia]

Erm,

how do you do you find the bug report 783622? do you have the link?

I googled it and nothing.

[Walter Roberson]

Bug reports can generally be found at http://www.mathworks.com/support/bugreports/

That particular one is either not present or not publicly visible.

Answer 4

[Rajiv Ghosh-Roy]

Bug report link.

I think you need to set the "release exists in" to R2011b.