Error with Simscape simulating

When i am trying to simulate, i get the following error:

_ Initial conditions solve failed to converge. ...The model may not give enough information to make it possible to solve for values of some of its variables. Specific advice is given below.

Tie variable 'Rectifier.Inductor.p.v' (v) to a definite value, for example by connecting an appropriate domain reference block.

Dependency found among topology equations. Check for missing reference node _

What i am supposed to do?

[Yogesh Kumar Mangal]

you can use ground refrence and run the programme

Answer 1

[Javier Gazzarri]

Hello, Nikolaos,

Your model is missing an electrical reference (ground). Please add one and let me know if you still get an error.

Thanks, Javier

[mobin]

Hi Mr.Javier Gazzarri.

I met the same problem while trying to scheme my IC (Im new in simscape) and your advice fixed my error . thanks

[Yogesh Kumar Mangal]

if we use transformer from simscape library component the we will use two ground refrence.

[Sai Sushma]

Ground was the issue in my case too!