How do I customize an Electrical Simscape block?
3 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
José Miguel Riquelme Domínguez
am 1 Dez. 2021
Beantwortet: Joel Van Sickel
am 22 Dez. 2021
Hi everyone,
I'm trying to modify the Active Power absorbed by a Three-Phase Series RLC Load during simulations. Something similar to which is described in the following link:
The first solution provided in the above link is to "Custom a Simscape Component", however, I'm not able to reach the source code of the cited block.
1) Do you have this source code?
2) Do you know an easier way to do what I am trying to do?
Thank you very much for your time,
Jose Miguel.
0 Kommentare
Antworten (1)
Joel Van Sickel
am 22 Dez. 2021
Hello Jose,
that block is a fundamental RLC block so it cannot be customized. You could customize the dynamic three phase load block instead. However, you might not even need to customize it as it might do what you are looking for.
Depending on what you are doing, you might want to switch to using simscape instead of specialized power systems. For most utility based simulaiton, I would prefer specialized power systems, but specifically for dynamic loads, simscape is often easier to use. This has to do with the fact that simscape can implement a time varying resistance, while specialized power systems can only mimic the behavior.
Regards,
Joel
0 Kommentare
Siehe auch
Kategorien
Mehr zu Nonlinear Operators finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!