Problem with Enable subsystem in simulink

I am simulating a Switched reluctance machine having 4 phases. Each phase is an enabled subsystem enabled by control signals generated from angle feedback. The problem is that even though the control signal is a pulse waveform varying from 0 to 1, the enable signal inside the subsystem is always shown to be 1 (observed from 'show output port'). This means the subsystem is always being enabled.

I am unable to resolve this issue. Please help asap.

Answer 1

[Chandrasekhar]

The output of the enable subsystem holds the value even if the subsystem is disabled. If you want to reset the output value do as shown in figure below

[avinash3010]

I looked into this.I want to use the enable signal within the subsystem, not as an output.

the enable signal outside the block is

but inside the block it is always 1