Simulate Simulink Model by Using MATLAB Language

To observe the non-real-time behavior of the model, simulate the Simulink^® model .

This procedure uses the Simulink model slrt_ex_osc_nrt. To open the model, in the MATLAB^® Command Window, type:

open_system(fullfile(matlabroot, 'toolbox', 'slrealtime', ...
'examples', 'slrt_ex_osc_nrt'))

Before you run the simulation, load this model. From the Modeling tab, click Model Settings. Enable Data Import/Export > Time variable tout and Data Import/Export > Output variable yout.

1. In the MATLAB Command Window, type:

   output=sim('slrt_ex_osc_nrt','SimulationMode','normal');

   The signal from the signal generator is logged to memory through the Outport block.

2. After Simulink finishes the simulation, type:

   plot(output.get('tout'), output.get('yout'))

   MATLAB opens a plot window and displays the output response.

   

When you change the model code generation target to slrealtime.tlc, build the model, and run the real-time application, the signal data for the MuxOut signal is sent to the Simulation Data Inspector. You can export the signal data from the Simulation Data Inspector. For more information, see Inspect and Compare Data Programmatically.