Beantwortet
Causing steady state error when conveting double (64 bit) data format to single (32 bit) format or run Simulink model on 32 bit processors such as Ti C2000.
Hi, Generate code for C2000, code runs on target with 32-bit floating point for the given double in the simulink model. Becau...

mehr als 8 Jahre vor | 0

Beantwortet
Error occurred while executing External Mode MEX-file 'ext_comm
Hi, Please update on the following: 1. Host operation system? i.e OS running on laptop... 2. Version of MATLAB, like 2017...

mehr als 8 Jahre vor | 0

Beantwortet
F28335 CAN communication reliability
Hi, Right now, via simulink block, we are not supporting viewing of the error flags that are inside the eCAN module . However...

mehr als 8 Jahre vor | 0

| akzeptiert

Beantwortet
Simulink External Mode not working on Texas Instruments C2000 Launchpad F28377S
Hi, With the release of R2016b, support package version 16.2.2, we are now supporting external mode on all the GPIO pins that...

mehr als 8 Jahre vor | 4

| akzeptiert

Beantwortet
Simulink eQEP block for speed calculation with C2000 MCU
Hi Armin, Right now, via our eQEP block, we are not supporting the monitoring of QEPST.UPEVNT signal in Simulink. Howe...

mehr als 8 Jahre vor | 0

Beantwortet
Error when building code for C2000 MCU in external mode
HI, please contact MathWorks Technical Support with necessary artifacts like Model used for us to reproduce and help on the erro...

mehr als 8 Jahre vor | 0

Beantwortet
Error when building code for C2000 MCU in external mode
Hi, This appears to be a redefinition error which probably could be related to compiler version being used. From the Error Lo...

mehr als 8 Jahre vor | 0

Beantwortet
Problem with serial communication on Texas Intruments C2000 Lauchpad F28377S
Hi, Could you please confirm from the device manager if the board is actually connected at COM port 6. We could use your mode...

mehr als 8 Jahre vor | 0

Beantwortet
Problem witth dead band in inverted ePWM - board TI C2000 F28377S
Hi, Please uncheck the ePWM7B pane completely as we need not configure the ePWM7B because the source for RED and FED is ePWM7...

mehr als 8 Jahre vor | 0

Beantwortet
Set C2000 Hardware Support Package Control Suite Directory Programmatically
Hi, When we run the targetupdater, we actually record the information that is provided during the support package configurati...

mehr als 8 Jahre vor | 0

Beantwortet
F28035 control stick. CLA error- Compilation failure gmake: *** [cla_task.obj] Error 1
Hi, If you can contact the Mathworks Tech Support and share the model in which you are seeing the error would be helpful. In...

fast 9 Jahre vor | 1

| akzeptiert

Beantwortet
In mathworks it is explained that C2000 Ramp Generator gives a ramp but I am not getting it
Hi, Attached is a model built in (2017a) which generates the ramp waveform. Regards, Venkatesh C

fast 9 Jahre vor | 0

| akzeptiert