Community Profile

photo

Ahmed Desoky


Last seen: fast 3 Jahre vor |  Aktiv seit 2016

Followers: 0   Following: 0

Statistiken

  • Revival Level 1
  • First Answer

Abzeichen anzeigen

Feeds

Anzeigen nach

Frage


How do I perform PID controller from error by using matlab script?
I want to change the PID that is shown in this figure to matlab script I am tring to use PID=Kp*ev + Ki * integral(ev)+ Kd ...

mehr als 4 Jahre vor | 0 Antworten | 0

0

Antworten

Beantwortet
Error while importing the excel file into signal builder
I have the same problem on 2016a. did you get a solution?

etwa 7 Jahre vor | 0

Frage


How to select some element from matrix by simulink?
I want to get all element except -1 By Simulink For example: u2 = [46.15 ; -22.5 ; -1 ; ...

etwa 8 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


How to find the index of the first non-zero element in a 2-D array in simulink?
I want to find the index of the first non-zero element in a 2-D array in simulink, just like the way that 'find' command in ...

etwa 8 Jahre vor | 0 Antworten | 1

0

Antworten

Frage


How to save video and images from usb webcam in Raspberry Pi by simulink?
I had connected the usb webcam to Raspberry Pi. I loaded the Simulink model that mention below onto Raspberry Pi board from the...

etwa 8 Jahre vor | 0 Antworten | 1

0

Antworten

Frage


How to execute the Simulink model from Raspberry Pi?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

etwa 8 Jahre vor | 0 Antworten | 0

0

Antworten

Frage


How to start Simulink model on Raspberry Pi automatically on startup?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

etwa 8 Jahre vor | 1 Antwort | 0

1

Antwort

Frage


How to do Simulink model run in Raspberry Pi after power on (booting) as standalone ?
I build a Simulink model to control Dc motor, load into the board, stop Simulink model and plug out the power and Ethernet cable...

etwa 8 Jahre vor | 0 Antworten | 0

0

Antworten