Community Profile

photo

phil


11 total contributions since 2013

Contact

phil's Badges

  • First Review
  • First Answer

View details...

Contributions in
View by

Answered
int16 to uint8 array conversion for Serial Transmit
Ok a little bit more resarch has turned out specifying data size in the model explorer works: :) <<https://i.imgur.com/PZffoq...

mehr als 2 Jahre ago | 0

Answered
int16 to uint8 array conversion for Serial Transmit
Your answer works fine in Matlab however in simulink i get port dimension errors. This is probably due to the fact that i could ...

mehr als 2 Jahre ago | 0

Question


int16 to uint8 array conversion for Serial Transmit
Hello there, I would like to take a int16 and split it into a uint8 array to transmit via serial connection (arduino). Then ...

mehr als 2 Jahre ago | 3 answers | 0

3

answers

Answered
See Generated code from Realtime workshop for Arduino
Hi Aj, thanks for your reply. That is exactly what i tried but then when i try to run the model on the hardware the follow...

etwa 5 Jahre ago | 0

Question


See Generated code from Realtime workshop for Arduino
Rather simple question: How can i see the generated code when i use the realtimeworkshop with the Arduino Target? deployme...

etwa 5 Jahre ago | 2 answers | 0

2

answers

Answered
arduino target with interrupt and i2c comunication
stuck on the same problem...cmon matlab!

mehr als 5 Jahre ago | 0

Answered
arduino target with interrupt and i2c comunication
I am stuck at the same problem! i have tried using the S function builder and was able to successfully send data over I2C to ano...

mehr als 5 Jahre ago | 0

Question


Simulink Support Package for Arduino Hardware/Ethernet Shield
Hello, I was wondering if somebody could point me into the right direction of how i can i get the TCP/UDP send/receive blocks...

mehr als 5 Jahre ago | 1 answer | 0

1

answer

Answered
Get ERROR when trying to upload 'Custom Simulink Block aka: S-Function Builder' to Arduino UNO
here is my very similar error: The build failed with the following message: "C:/MATLAB/Targets/R2012b/arduino-1.0/hardware/to...

mehr als 6 Jahre ago | 0

Question


How to write Driver Blocks for Arduino on the new 2012b Version?
Following the guide "Writing a Simulink Device Driver block: a step by step guide" by Campa I have not been able to successfully...

mehr als 6 Jahre ago | 0 answers | 0

0

answers

Answered
lcd display with matlab simulink
hey klob... i am currently doing the exact same thing. i have had partial success!... google this: Writing a Simulink Device...

fast 7 Jahre ago | 0