Community Profile

photo

Sarala Gurijala


Last seen: 3 Monate vor Aktiv seit 2022

Statistiken

  • Thankful Level 2

Abzeichen anzeigen

Content Feed

Anzeigen nach

Frage


why is the same mpc code giving different solutions, when it is simulated for after a month.
I have written a code for mpc and it gave correct results when I simulated it 3 months before, now I opened the same code and ex...

6 Monate vor | 0 Antworten | 0

0

Antworten

Beantwortet
how to rectify the LPV block error caused by "Model arrays containing more than one models at a scheduling point cannot be used in LPV block"
This error can be resolved by relaxing the constraints on Inputs or outputs.

11 Monate vor | 0

| akzeptiert

Frage


how to rectify the LPV block error caused by "Model arrays containing more than one models at a scheduling point cannot be used in LPV block"
hi I'm applying adaptive MPC with LPV to a 2 input, 2state, 2output system and I have initialised 3 state space models by provi...

12 Monate vor | 1 Antwort | 0

1

Antwort

Frage


How can I know the Cost function expression used in MPC command line, when I use 'sim' command
hi I have used sim command to solve the MPC problem, with weighting matrices for MV,MVRate and OV. And also I have given the co...

etwa ein Jahr vor | 0 Antworten | 0

0

Antworten

Frage


I'm getting the following error while doing the state update in mpc
I'm applying mpc for 2input, 1output system with 2states. and I'm unable to make the system state update. For the above code ...

etwa ein Jahr vor | 1 Antwort | 0

1

Antwort

Frage


how to choose the alternate cost function in MPC command line window? and can we know which cost function MPC block is considering?
hi I'm using the MPC for reference tracking and able to see the value of cost function. but I'm unable to check the type of cos...

etwa ein Jahr vor | 1 Antwort | 0

1

Antwort

Frage


why linear MPC is not tracking the reference value? when I changed OV constraint and reference both for the same system
For the MPC controller, I have given the reference value and OV constraint (e.g,7), both are equal. It worked. and I tried by ch...

etwa ein Jahr vor | 0 Antworten | 0

0

Antworten

Frage


Can we equate or un-equate the two MV's of the MPC controller in command line?
Hi I have the system with 2inputs, 1output, in that I need to give the constraints for 2MV's and the constraint range(min&max) ...

etwa ein Jahr vor | 1 Antwort | 0

1

Antwort