It is possible to change the values of the simulink frpm the Gui?

hi, i wanna buid a gui, where i can write values and after pressing the button "start" the simulink should take these values.

It is possible???

THX

[Kaustubha Govind]

Will the GUI provide a single value for each input that needs to be used as a Constant input for the entire simulation, will it provide a set of values to use from StartTime to StopTime, or does the model need to read from the GUI at each time-step to get the value?

[sia]

the first one! I edit a value and the simulation takes this value for their input.

[sia]

i would like to show you a picture bit i dont know ow i can upload it :(

Answer 1

[Arunkumar Muthukumaran]

Use set_param() to access and update the value of constant blocks. This command will dynamically update the values during simulation.