Target support package, c2000, C28x3X. eCAN Transmit

Hello, I´m using an F28335 board to connect to another device by eCAN.

To send different messages I need to change the “Message identifier” in the block “eCAN Transmit” but it is a parameter (cannot be changed in real time). There is some way to change “Message identifier” using a signal?

CAN Pack has the same problem.

Answer 1

[Raphael]

Hello, i´m not sure but i think you have to create a new "eCan Transmit" - block for each "Message identifier".

[Hugo]

It works for models with less than 32 different ID’s. Each block need a different mailbox number (limit 32). I need to transmit around 100 different ID’s.