A timeout occurred before the Terminator was reached. first

22 Ansichten (letzte 30 Tage)
samir
samir am 2 Apr. 2012
Kommentiert: kiarash am 29 Apr. 2021
ok this is my code
s=serial('com5');
set(s,'BaudRate',9600,'DataBits', 8, 'Parity', 'none','StopBits', 1, 'FlowControl', 'none','Terminator','CR');
fopen(s);
while(1)
fprintf(s,'0');
pause(0.5);
data=fscanf(s);
data=str2num(data);
display(data);
if(data<=10)
fprintf(s,'1');
pause(0.5);
fprintf(s,'2');
pause(0.5);
fprintf(s,'3');
pause(0.5);
fprintf(s,'0');
pause(0.5);
data=fscanf(s);
data=str2num(data);
display('first');
i=0;
if(data<=10)
fprintf(s,'2');
pause(0.5);
i=i+1;
end
display('second');
end
end
fprintf(s,''1') fprintf(s,''2') fprintf(s,''3') are just commands sending in one direction so no returned data is excepted
fprintf(s,''0') sends a command to a roboter to use his pingsenzor the roboter returns a value stored in data(by the way the returned data from the roboter is [DEC distance, CR] -dec meaning decimal ,distance - variable,CR - terminator)
if the returned value is <10 then try to avoid the object.When i use a second time fprintf(s,'0') i always get the message
Warning: A timeout occurred before the Terminator was reached. first last
so why does this always appears the second time and how to avoid it.
  1 Kommentar
Hoang Nguyen
Hoang Nguyen am 17 Sep. 2015
I had the same your error when arduino uno was interfacing with matlab :(. I don't know how to solve this problem

Melden Sie sich an, um zu kommentieren.

Akzeptierte Antwort

samir
samir am 2 Apr. 2012
ok i put an puase (2) before fprintf(s,'0'); and it works now wihtout the error.Don't know why it works now or why it didn't work earlier but at least it works now

Weitere Antworten (1)

Hoang Nguyen
Hoang Nguyen am 17 Sep. 2015
hi every body! i used "Encoder Read" block in simulink to read value encoder of my motor. but if my motor operate with hight speed then following error occurred: "Error evaluating registered method 'Outputs' of MATLAB S-Function 'msfun_arduino_encoderread' in 'DaoChieuDongCo/Encoder Read'. The following is the MATLAB call stack (file names and line numbers) that produced this error: ['C:\MATLAB\SupportPackages\R2013b\ArduinoIO\simulink\msfun_arduino_encoderread.m'] [100]
Caused by: Invalid assignment in 'DaoChieuDongCo/Encoder Read': attempt to assign a matrix to a vector" so, how do i solve this error?
  2 Kommentare
Waldri
Waldri am 13 Aug. 2020
In my case I change the baud rate in arduino to 500000
kiarash
kiarash am 29 Apr. 2021
Hi,
Please check the help of "baudrate". Maximum allowed value I think was 115200.

Melden Sie sich an, um zu kommentieren.

Kategorien

Mehr zu Simulink Supported Hardware finden Sie in Help Center und File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by